Currently we check whether LR is stored/loaded to/from inbetween the
loop decrement and loop end pseudo instructions. There's two problems
here:
- It relies on all load/store instructions being labelled as such in
tablegen.
- Actually any use of loop decrement is troublesome because the value
doesn't exist!
So we need to check for any read/write of LR that occurs between the
two instructions and revert if we find anything.
Differential Revision: https://reviews.llvm.org/D65792
llvm-svn: 368130
Revert the hardware loop upon finding a LoopEnd that doesn't target
the loop header, instead of asserting a failure.
Differential Revision: https://reviews.llvm.org/D65268
llvm-svn: 367296
ARMLowOverheadLoops would assert a failure if it did not find all the
pseudo instructions that comprise the hardware loop. Instead of doing
this, iterate through all the instructions of the function and revert
any remaining pseudo instructions that haven't been converted.
Differential Revision: https://reviews.llvm.org/D65080
llvm-svn: 366691
This patch addresses a couple of problems:
1) The maximum supported offset of LE is -4094.
2) The offset of WLS also needs to be checked, this uses a
maximum positive offset of 4094.
The use of BasicBlockUtils has been changed because the block offsets
weren't being initialised, but the isBBInRange checks both positive
and negative offsets.
ARMISelLowering has been tweaked because the test case presented
another pattern that we weren't supporting.
llvm-svn: 365749
Backend changes to enable WLS/LE low-overhead loops for armv8.1-m:
1) Use TTI to communicate to the HardwareLoop pass that we should try
to generate intrinsics that guard the loop entry, as well as setting
the loop trip count.
2) Lower the BRCOND that uses said intrinsic to an Arm specific node:
ARMWLS.
3) ISelDAGToDAG the node to a new pseudo instruction:
t2WhileLoopStart.
4) Add support in ArmLowOverheadLoops to handle the new pseudo
instruction.
Differential Revision: https://reviews.llvm.org/D63816
llvm-svn: 364733
The expensive buildbots highlighted the mir tests were broken, which
I've now updated and added --verify-machineinstrs to them. This also
uncovered a couple of bugs in the backend pass, so these have also
been fixed.
llvm-svn: 364323
Introduce three pseudo instructions to be used during DAG ISel to
represent v8.1-m low-overhead loops. One maps to set_loop_iterations
while loop_decrement_reg is lowered to two, so that we can separate
the decrement and branching operations. The pseudo instructions are
expanded pre-emission, where we can still decide whether we actually
want to generate a low-overhead loop, in a new pass:
ARMLowOverheadLoops. The pass currently bails, reverting to an sub,
icmp and br, in the cases where a call or stack spill/restore happens
between the decrement and branching instructions, or if the loop is
too large.
Differential Revision: https://reviews.llvm.org/D63476
llvm-svn: 364288
