default
During the lowering of a switch that would result in the generation of a jump
table, a range check is performed before indexing into the jump table, for the
switch value being outside the jump table range and a conditional branch is
inserted to jump to the default block. In case the default block is
unreachable, this conditional jump can be omitted. This patch implements
omitting this conditional branch for unreachable defaults.
Review Reference: D52002
llvm-svn: 350186
The patch adds a possibility to make library calls on NVPTX.
An important thing about library functions - they must be defined within
the current module. This basically should guarantee that we produce a
valid PTX assembly (without calls to not defined functions). The one who
wants to use the libcalls is probably will have to link against
compiler-rt or any other implementation.
Currently, it's completely impossible to make library calls because of
error LLVM ERROR: Cannot select: i32 = ExternalSymbol '...'. But we can
lower ExternalSymbol to TargetExternalSymbol and verify if the function
definition is available.
Also, there was an issue with a DAG during legalisation. When we expand
instruction into libcall, the inner call-chain isn't being "integrated"
into outer chain. Since the last "data-flow" (call retval load) node is
located in call-chain earlier than CALLSEQ_END node, the latter becomes
a leaf and therefore a dead node (and is being removed quite fast).
Proposed here solution relies on another data-flow pseudo nodes
(ProxyReg) which purpose is only to keep CALLSEQ_END at legalisation and
instruction selection phases - we remove the pseudo instructions before
register scheduling phase.
Patch by Denys Zariaiev!
Differential Revision: https://reviews.llvm.org/D34708
llvm-svn: 350069
This is an alternative to what I attempted in D56057.
GetDemandedBits is a special version of SimplifyDemandedBits that allows simplifications even when the operand has other uses. GetDemandedBits will only do simplifications that allow a node to be bypassed. It won't create new nodes or alter any of the other users.
I had to add support for bypassing SIGN_EXTEND_INREG to GetDemandedBits.
Based on a patch that Simon Pilgrim sent me in email.
Fixes PR40142.
llvm-svn: 350059
More migration so we can disable the implicit int -> LocationSize
conversion.
All of these are either scatter/gather'ed vector instructions, or direct
loads. Hence, they're all precise.
Perhaps if we see way more getTypeStoreSize calls, we can make a
getTypeStoreLocationSize (or similar) as a wrapper that applies this
::precise. Doesn't appear that it's a good idea to make getTypeStoreSize
return a LocationSize itself, however.
llvm-svn: 350042
It's dangerous to knowingly create an illegal vector type
no matter what stage of combining we're in.
This prevents the missed folding/scalarization seen in:
https://bugs.llvm.org/show_bug.cgi?id=40146
llvm-svn: 350034
trunc (add X, C ) --> add (trunc X), C'
If we're throwing away the top bits of an 'add' instruction, do it in the narrow destination type.
This makes the truncate-able opcode list identical to the sibling transform done in IR (in instcombine).
This change used to show regressions for x86, but those are gone after D55494.
This gets us closer to deleting the x86 custom function (combineTruncatedArithmetic)
that does almost the same thing.
Differential Revision: https://reviews.llvm.org/D55866
llvm-svn: 350006
This saves materializing the immediate. The additional forms are less
common (they don't usually show up for bitfield insert/extract), but
they're still relevant.
I had to add a new target hook to prevent DAGCombine from reversing the
transform. That isn't the only possible way to solve the conflict, but
it seems straightforward enough.
Differential Revision: https://reviews.llvm.org/D55630
llvm-svn: 349857
This patch enables funnel shift -> rotate building for all ROTL/ROTR custom/legal operations.
AFAICT X86 was the last target that was missing modulo support (PR38243), but I've tried to CC stakeholders for every target that has ROTL/ROTR custom handling for their final OK.
Differential Revision: https://reviews.llvm.org/D55747
llvm-svn: 349765
Now that SimplifyDemandedBits/SimplifyDemandedVectorElts is simplifying vector elements, we're seeing more constant BUILD_VECTOR containing undefs.
This patch provides opt-in support for UNDEF elements in matchBinaryPredicate, passing NULL instead of the result ConstantSDNode* argument.
I've updated the (or (and X, c1), c2) -> (and (or X, c2), c1|c2) fold to demonstrate its use, which I believe is safe for undef cases.
Differential Revision: https://reviews.llvm.org/D55822
llvm-svn: 349629
Now that SimplifyDemandedBits/SimplifyDemandedVectorElts is simplifying vector elements, we're seeing more constant BUILD_VECTOR containing undefs.
This patch provides opt-in support for UNDEF elements in matchBinaryPredicate, passing NULL instead of the result ConstantSDNode* argument.
Differential Revision: https://reviews.llvm.org/D55822
llvm-svn: 349628
As described on PR40091, we have several places where zext (and zext_vector_inreg) fold an undef input into an undef output. For zero extensions this is incorrect as the output should guarantee to least have the new upper bits set to zero.
SimplifyDemandedVectorElts is the worst offender (and its the most likely to cause new undefs to appear) but DAGCombiner's tryToFoldExtendOfConstant has a similar issue.
Thanks to @dmgreen for catching this.
Differential Revision: https://reviews.llvm.org/D55883
llvm-svn: 349625
Now that SimplifyDemandedBits/SimplifyDemandedVectorElts are simplifying vector elements, we're seeing more constant BUILD_VECTOR containing UNDEFs.
This patch provides opt-in handling of UNDEF elements in matchUnaryPredicate, passing NULL instead of the ConstantSDNode* argument.
I've updated SelectionDAG::simplifyShift to demonstrate its use.
Differential Revision: https://reviews.llvm.org/D55819
llvm-svn: 349616
SelectionDAG currently changes these intrinsics to function calls, but that won't work
for other ISel's. Also we want to eventually support nonlazybind and weak linkage coming
from the front-end which we can't do in SelectionDAG.
llvm-svn: 349552
For opcodes not covered by SimplifyDemandedVectorElts, SimplifyDemandedBits might be able to help now that it supports demanded elts as well.
llvm-svn: 349466
The assertion type is always supposed to be a scalar type. So if the result VT of the assertion is a vector, we need to get the scalar VT before we can compare them.
Similarly for the assert above it.
I don't have a test case because I don't know of any place we violate this today. A coworker found this while trying to use r347287 on the 6.0 branch without also having r336868
llvm-svn: 349390
This is an initial patch to add the necessary support for a DemandedElts argument to SimplifyDemandedBits, more closely matching computeKnownBits and to help improve vector codegen.
I've added only a small amount of the changes necessary to get at least one test to update - a lot more can be done but I'd like to add these methodically with proper test coverage, at the same time the hope is to slowly move some/all of SimplifyDemandedVectorElts into SimplifyDemandedBits as well.
Differential Revision: https://reviews.llvm.org/D55768
llvm-svn: 349374
We keep a few iterators into the basic block we're selecting while
performing FastISel. Usually this is fine, but occasionally code wants
to remove already-emitted instructions. When this happens we have to be
careful to update those iterators so they're not pointint at dangling
memory.
llvm-svn: 349365
The transform performs a bitwise logic op in a wider type followed by
truncate when both inputs are truncated from the same source type:
logic_op (truncate x), (truncate y) --> truncate (logic_op x, y)
There are a bunch of other checks that should prevent doing this when
it might be harmful.
We already do this transform for scalars in this spot. The vector
limitation was shared with a check for the case when the operands are
extended. I'm not sure if that limit is needed either, but that would
be a separate patch.
Differential Revision: https://reviews.llvm.org/D55448
llvm-svn: 349303
Also exposes an issue in DAGCombiner::visitFunnelShift where we were assuming the shift amount had the result type (after legalization it'll have the targets shift amount type).
llvm-svn: 349298
Summary:
If the setcc already has the target desired type we can reach the getSetCC/getSExtOrTrunc after the MatchingVecType check with the exact same types as the nodes we started with. This causes those causes VsetCC to be CSEd to N0 and the getSExtOrTrunc will CSE to N. When we return N, the caller will think that meant we called CombineTo and did our own worklist management. But that's not what happened. This prevents target hooks from being called for the node.
To fix this, I've now returned SDValue if the setcc is already the desired type. But to avoid some regressions in X86 I've had to disable one of the target combines that wasn't being reached before in the case of a (sext (setcc)). If we get vector widening legalization enabled that entire function will be deleted anyway so hopefully this is only for the short term.
Reviewers: RKSimon, spatel
Subscribers: llvm-commits
Differential Revision: https://reviews.llvm.org/D55459
llvm-svn: 349137
This isn't quite NFC, but I don't know how to expose
any outward diffs from these changes. Mostly, this
was confusing because it used 'VT' to refer to the
operand type rather the usual type of the input node.
There's also a large block at the end that is dedicated
solely to matching loads, but that wasn't obvious. This
could probably be split up into separate functions to
make it easier to see.
It's still not clear to me when we make certain transforms
because the legality and constant conditions are
intertwined in a way that might be improved.
llvm-svn: 349095
This is a retry of rL349051 (reverted at rL349056). I changed the check for dead-ness from
number of uses to an opcode test for DELETED_NODE based on existing similar code.
Differential Revision: https://reviews.llvm.org/D55655
llvm-svn: 349058
Move existing rotation expansion code into TargetLowering and set it up for vectors as well.
Ideally this would share more of the funnel shift expansion, but we handle the shift amount modulo quite differently at the moment.
Begun removing x86 vector rotate custom lowering to use the expansion.
llvm-svn: 349025
Summary:
All targets either just return false here or properly model `Fast`, so I
don't think there is any reason to prevent CodeGen from doing the right
thing here.
Subscribers: nemanjai, javed.absar, eraman, jsji, llvm-commits
Differential Revision: https://reviews.llvm.org/D55365
llvm-svn: 349016
This patch introduces a generic function to determine whether a given vector type is known to be a splat value for the specified demanded elements, recursing up the DAG looking for BUILD_VECTOR or VECTOR_SHUFFLE splat patterns.
It also keeps track of the elements that are known to be UNDEF - it returns true if all the demanded elements are UNDEF (as this may be useful under some circumstances), so this needs to be handled by the caller.
A wrapper variant is also provided that doesn't take the DemandedElts or UndefElts arguments for cases where we just want to know if the SDValue is a splat or not (with/without UNDEFS).
I had hoped to completely remove the X86 local version of this function, but I'm seeing some regressions in shift/rotate codegen that will take a little longer to fix and I hope to get this in sooner so I can continue work on PR38243 which needs more capable splat detection.
Differential Revision: https://reviews.llvm.org/D55426
llvm-svn: 348953
If either of the operand elements are zero then we know the result element is going to be zero (even if the other element is undef).
Differential Revision: https://reviews.llvm.org/D55558
llvm-svn: 348926
Add an intrinsic that takes 2 signed integers with the scale of them provided
as the third argument and performs fixed point multiplication on them.
This is a part of implementing fixed point arithmetic in clang where some of
the more complex operations will be implemented as intrinsics.
Differential Revision: https://reviews.llvm.org/D54719
llvm-svn: 348912
Summary:
All targets either just return false here or properly model `Fast`, so I
don't think there is any reason to prevent CodeGen from doing the right
thing here.
Subscribers: nemanjai, javed.absar, eraman, jsji, llvm-commits
Differential Revision: https://reviews.llvm.org/D55365
llvm-svn: 348843
If all the demanded elements of the SimplifyDemandedVectorElts are known to be UNDEF, we can simplify to an ISD::UNDEF node.
Zero constant folding will be handled in a future patch - its a little trickier as we often have bitcasted zero values.
Differential Revision: https://reviews.llvm.org/D55511
llvm-svn: 348784
As discussed on D55511, this caused an issue if the inner node deletes a node that the outer node depends upon. As it doesn't affect any lit-tests and I've only been able to expose this with the D55511 change I'm committing this now.
llvm-svn: 348781
This triggers an assert when combining concat_vectors of a bitcast of
merge_values.
With asserts disabled, it fails to select:
fatal error: error in backend: Cannot select: 0x7ff19d000e90: i32 = any_extend 0x7ff19d000ae8
0x7ff19d000ae8: f64,ch = CopyFromReg 0x7ff19d000c20:1, Register:f64 %1
0x7ff19d000b50: f64 = Register %1
In function: d
Differential Revision: https://reviews.llvm.org/D55507
llvm-svn: 348759
Currently, dbg.value's of "nullptr" are dropped when entering a SelectionDAG --
apparently just because of an oversight when recognising Values that are
constant (see PR39787). This patch adds ConstantPointerNull to the list of
constants that can be turned into DBG_VALUEs.
The matter of what bit-value a null pointer constant in LLVM has was raised
in this mailing list thread:
http://lists.llvm.org/pipermail/llvm-dev/2018-December/128234.html
Where it transpires LLVM relies on (IR) null pointers being zero valued,
thus I've baked this assumption into the patch.
Differential Revision: https://reviews.llvm.org/D55227
llvm-svn: 348753
