This custom inserter existed so we could do a weird thing where we pretended that the instructions support
a full address mode instead of taking a pointer in EAX/RAX. I think was largely so we could be pointer
size agnostic in the isel pattern.
To make this work we would then put the address into an LEA into EAX/RAX in front of the instruction after
isel. But the LEA is overkill when we just have a base pointer. So we end up using the LEA as a slower MOV
instruction.
With this change we now just do custom selection during isel instead and just assign the incoming address
of the intrinsic into EAX/RAX based on its size. After the intrinsic is selected, we can let isel take
care of selecting an LEA or other operation to do any address computation needed in this basic block.
I've also split the instruction into a 32-bit mode version and a 64-bit mode version so the implicit
use is properly sized based on the pointer. Without this we get comments in the assembly output about
killing eax and defing rax or vice versa depending on whether we define the instruction to use EAX/RAX.
llvm-svn: 357652
Enable enableMultipleCopyHints() on X86.
Original Patch by @jonpa:
While enabling the mischeduler for SystemZ, it was discovered that for some reason a test needed one extra seemingly needless COPY (test/CodeGen/SystemZ/call-03.ll). The handling for that is resulted in this patch, which improves the register coalescing by providing not just one copy hint, but a sorted list of copy hints. On SystemZ, this gives ~12500 less register moves on SPEC, as well as marginally less spilling.
Instead of improving just the SystemZ backend, the improvement has been implemented in common-code (calculateSpillWeightAndHint(). This gives a lot of test failures, but since this should be a general improvement I hope that the involved targets will help and review the test updates.
Differential Revision: https://reviews.llvm.org/D38128
llvm-svn: 342578
Summary:
MONITORX/MWAITX instructions provide similar capability to the MONITOR/MWAIT
pair while adding a timer function, such that another termination of the MWAITX
instruction occurs when the timer expires. The presence of the MONITORX and
MWAITX instructions is indicated by CPUID 8000_0001, ECX, bit 29.
The MONITORX and MWAITX instructions are intercepted by the same bits that
intercept MONITOR and MWAIT. MONITORX instruction establishes a range to be
monitored. MWAITX instruction causes the processor to stop instruction execution
and enter an implementation-dependent optimized state until occurrence of a
class of events.
Opcode of MONITORX instruction is "0F 01 FA". Opcode of MWAITX instruction is
"0F 01 FB". These opcode information is used in adding tests for the
disassembler.
These instructions are enabled for AMD's bdver4 architecture.
Patch by Ganesh Gopalasubramanian!
Reviewers: echristo, craig.topper, RKSimon
Subscribers: RKSimon, joker.eph, llvm-commits
Differential Revision: http://reviews.llvm.org/D19795
llvm-svn: 269911
