Recent upstream trends have moved away from explicitly using `-verify-machineinstrs`, as it's already covered by the expensive checks. This PR removes almost all `-verify-machineinstrs` from tests in `llvm/test/CodeGen/AMDGPU/*.ll`, leaving only those tests where its removal currently causes failures.
The existing way of managing clustered nodes was done through adding
weak edges between the neighbouring cluster nodes, which is a sort of
ordered queue. And this will be later recorded as `NextClusterPred` or
`NextClusterSucc` in `ScheduleDAGMI`.
But actually the instruction may be picked not in the exact order of the
queue. For example, we have a queue of cluster nodes A B C. But during
scheduling, node B might be picked first, then it will be very likely
that we only cluster B and C for Top-Down scheduling (leaving A alone).
Another issue is:
```
if (!ReorderWhileClustering && SUa->NodeNum > SUb->NodeNum)
std::swap(SUa, SUb);
if (!DAG->addEdge(SUb, SDep(SUa, SDep::Cluster)))
```
may break the cluster queue.
For example, we want to cluster nodes (order as in `MemOpRecords`): 1 3
2. 1(SUa) will be pred of 3(SUb) normally. But when it comes to (3, 2),
As 3(SUa) > 2(SUb), we would reorder the two nodes, which makes 2 be
pred of 3. This makes both 1 and 2 become preds of 3, but there is no
edge between 1 and 2. Thus we get a broken cluster chain.
To fix both issues, we introduce an unordered set in the change. This
could help improve clustering in some hard case.
One key reason the change causes so many test check changes is: As the
cluster candidates are not ordered now, the candidates might be picked
in different order from before.
The most affected targets are: AMDGPU, AArch64, RISCV.
For RISCV, it seems to me most are just minor instruction reorder, don't
see obvious regression.
For AArch64, there were some combining of ldr into ldp being affected.
With two cases being regressed and two being improved. This has more
deeper reason that machine scheduler cannot cluster them well both
before and after the change, and the load combine algorithm later is
also not smart enough.
For AMDGPU, some cases have more v_dual instructions used while some are
regressed. It seems less critical. Seems like test `v_vselect_v32bf16`
gets more buffer_load being claused.
We haven't implemented 16 bit SGPRs. Currently allow 32-bit SGPRs to be
folded into True16 bit instructions taking 16 bit values. Also use
sgpr_32 when Imm is copied to spgr_lo16 so it could be further folded.
This improves generated code quality.
We have a VALU->SGPR->SALU (VALU writing to SGPR and SALU reading from
it). When VALU is issued, it increments internal counter VA_SDST used to
track use of this SGPR. SALU will not issue until VA_SDST is zero, that
is when VALU is finished writing. Therefore, delays added by s_delay_alu
are not needed in this situation.
We have a VALU->SGPR->SALU (VALU writing to SGPR and SALU reading from
it). When VALU is issued, it increments internal counter VA_SDST used to
track use of this SGPR. SALU will not issue until VA_SDST is zero, that
is when VALU is finished writing. Therefore, delays added by s_delay_alu
are not needed in this situation.
MSG_DEALLOC_VGPRS slows down very small waveslot limited kernels. It's
been identified this message is only really needed for VGPR limited
kernels. A kernel becomes VGPR limited if a total number of VGPRs per
SIMD / number of used VGPRs is more than a number of wave slots.
This reverts commit adaff46d087799072438dd744b038e6fd50a2d78.
Drop the -O3 checks from default-attributes.hip. I don't know why they
are different on some bots but reverting this is far too disruptive.
Removing it from the codegen pipeline induces a lot of test churn
because llc is no longer optimizing out implicit arguments to kernels.
Mostly mechanical, but there are some creative test updates. I preferred
to take the changes as-is in tests where the ABI isn't relevant. In
cases where it's more relevant, or the optimize out logic was too
ingrained in the test, I pre-run the optimization. Some cases manually
add attributes to disable inputs.
Similar to 806761a7629df268c8aed49657aeccffa6bca449.
For IR files without a target triple, -mtriple= specifies the full
target triple while -march= merely sets the architecture part of the
default target triple, leaving a target triple which may not make sense,
e.g. amdgpu-apple-darwin.
Therefore, -march= is error-prone and not recommended for tests without
a target triple. The issue has been benign as we recognize
$unknown-apple-darwin as ELF instead of rejecting it outrightly.
This patch changes AMDGPU tests to not rely on the default
OS/environment components. Tests that need fixes are not changed:
```
LLVM :: CodeGen/AMDGPU/fabs.f64.ll
LLVM :: CodeGen/AMDGPU/fabs.ll
LLVM :: CodeGen/AMDGPU/floor.ll
LLVM :: CodeGen/AMDGPU/fneg-fabs.f64.ll
LLVM :: CodeGen/AMDGPU/fneg-fabs.ll
LLVM :: CodeGen/AMDGPU/r600-infinite-loop-bug-while-reorganizing-vector.ll
LLVM :: CodeGen/AMDGPU/schedule-if-2.ll
```
We were missing legality checks. The device library build was broken
for targets without f16 support. Technically the first pattern isn't
tested by this patch; it only triggers with the isBeforeLegalize check
in performAndCombine removed. I'm not sure how to trick this into
appearing post-legalization.
Currently the default C calling convention functions are treated
the same as compute kernels. Make this explicit so the default
calling convention can be changed to a non-kernel.
Converted with perl -pi -e 's/define void/define amdgpu_kernel void/'
on the relevant test directories (and undoing in one place that actually
wanted a non-kernel).
llvm-svn: 298444
